1. Material: Complete leopard skin;
2. methods: measure the shape should be measured body length, neck length, leg length, tail length, neck, bust, waist circumference, each leg section diameter and the distance between the forelimbs, the rear limbs and the front and rear limbs, etc.
3. Treatment skins: first with soapy water to wash off the oil on the inside of the skin, and then the skin immersed in the convergence liquid for more than 20 hours to remove the skin, in its inner coated with 30% aral acid anhydride, 10% camphor soft soap paste, to prevent insect decay.
4. alse institutional practice: with soft wood according to the shape of the skull, size carving, the jaw bone to do another, according to the mouth of the moderate connection to the bottom of the skull, teeth made of resin glue turn mold, mounted on the upper and lower jaw shards, carved skull in the back of the skull left a groove-shaped cruciate, in order to connect with the neck, torso and limbs of the middle shaft to make wood, according to the neck, according to the neck, The upper and lower edges of the torso shape are made of a positive center-shaped plate, until the tail end, and the shape of the limbs is made into a target-shaped plank, and then according to the distance between the limbs connected to the neck, torso of the center of the target plate, you can stand.
When installing limbs should pay attention to dynamic posture, the lower end of the limbs target plate should be longer than the shape of the foot more than 10cm, easy to fix with the specimen seat, and finally, with hard-fitting plastic foam plate to the sides of the target board, so that the thickness of the ministries to achieve the required thickness, with a knife to cut off the excess part, installed wood carving head, cutting off the excess part of the steps is very important.
It is necessary to refer to the data measured by various departments and some auxiliary information, so that after the end of this step, the male posture of the leopard is wrapped in a thin sponge on the surface of the prosthesis, which is conducive to the prosthesis into the skin better combined with the skin, and can prevent some hard damage to the skin plate when the foreskin, so that the specimen has a sense of elasticity.
